Reset process

1. Switch-off the printer.
2. Press and hold the on/off button.
3. When all the LEDs turn on, open the cover and remove the toner cartridge + drum unit.
4. Release the on/off button.
5. Re-install the toner cartridge + drum unit back into the printer and close the printer cover.

How do you reset a brother laser printer?

• Factory reset your brother laser printer: Turn off your brother printer. Press and hold down the go button. With the go button still held, turn on it back on again. When the three lights light up, release the button and then press the go button TEN times. Wait until the ready light is lit.

How do I get my Brother printer to recognize toner cartridges?

Turn off the power and unplug the printer from the outlet and let it sit for 10 or so minutes. Plug it back in and re-insert the cartridge. Turn the power back on and this should work and your new cartridge should work!

How do I reset my Brother HL L3230CDW Toner message?

HL-L3210CW, HL-L3230CDW

1. Open the front cover of the printer (to access cartridges).
2. With the cover open, simultaneously press the Back and Cancel buttons.
3. Scroll through the menu to select a color and yield to reset.
4. The LCD will read “Accepted” once the reset is complete.

How do you bypass toner chip?

To bypass your toner or ink chip you can do any of four things.

1. Use an auto-reset ink tanks if your printer models have them.
2. Fit your printer with a new chip or ink tank.
3. Use your printer model’s chip resetter to restore the “empty” chip to full.
4. Disable your ink or toner monitor.

How do I reset my Brother HL L2350dw toner?

How to Reset Toner on Brother HL-L2350dw, HL-L2370dw

1. With power on, open the front cover.
2. Press BACK and GO buttons at the same time.
3. Press BACK button one more time by itself.
4. Press Down Arrow to select the correct toner type:

How do I force my printer to print with low toner?

How I Forced My Printer To Print in Low Ink

1. What you need to do is remove the ink cartridge/s.
2. Look for the clear part of the cartridge. ( Usually found near the nozzle.
3. Once you located the transparent side of the cartridge, cut a strip of tape. Then cover the mentioned part of the ink cartridge.
4. That’s it!

Why does my Brother printer keep saying no toner?

The message ‘No Toner’ indicates that the toner cartridge or the toner cartridge and drum unit are not installed correctly. Remove the toner cartridge from the drum by holding down the green lock lever on the left side of the drum unit and lifting the toner out. Handle the toner cartridge carefully.

How do I reset my brother tn 420 toner?

Press the “Go” button 2 times – The “Toner, Drum, and Error” LEDs will turn ON. Press the “Go” button 6 times for a TN420 or Press the “Go” button 7 times for Brother TN450. Close the front cover after “Error” LED starts to flash. Finally, The reset procedure has been completed.

How do you reset the toner on a Brother HL L2370dw?

How to Reset Toner on Brother HL-L2370dw Printer

1. With power ON, open the front cover.
2. Press BACK and GO buttons at the same time.
3. Press BACK button only one more time.
4. Press down arrow to select TNR-HC (for high yield toner)
5. Press OK.
6. Press down arrow to confirm ACCEPTED.
7. Close front cover and you should be good to go!